Skip to main content
4-058.9

APPENDIX A—Capital Adequacy Guidelines for Bank Holding Companies: Risk-Based Measure*

I. Overview
The Board of Governors of the Federal Reserve System has adopted a risk-based capital measure to assist in the assessment of the capital adequacy of bank holding companies (“banking organizations”).1 The principal objectives of this measure are to (i) make regulatory capital requirements more sensitive to differences in risk profiles among banking organizations; (ii) factor off-balance-sheet exposures into the assessment of capital adequacy; (iii) minimize disincentives to holding liquid, low-risk assets; and (iv) achieve greater consistency in the evaluation of the capital adequacy of major banking organizations throughout the world.2
The risk-based capital guidelines include both a definition of capital and a framework for calculating weighted-risk assets by assigning assets and off-balance-sheet items to broad risk categories. An institution’s risk-based capital ratio is calculated by dividing its qualifying capital (the numerator of the ratio) by its weighted-risk assets (the denominator).3 The definition of “qualifying capital” is outlined below in section II, and the procedures for calculating weighted-risk assets are discussed in section III. Attachment I illustrates a sample calculation of weighted-risk assets and the risk-based capital ratio.
In addition, when certain organizations that engage in trading activities calculate their risk-based capital ratio under this appendix A, they must also refer to appendix E of this part, which incorporates capital charges for certain market risks into the risk-based capital ratio. When calculating their risk-based capital ratio under this appendix A, such organizations are required to refer to appendix E of this part for supplemental rules to determine qualifying and excess capital, calculate risk-weighted assets, calculate market-risk-equivalent assets, and calculate risk-based capital ratios adjusted for market risk.
The risk-based capital guidelines also establish a schedule for achieving a minimum supervisory standard for the ratio of qualifying capital to weighted-risk assets and provide for transitional arrangements during a phase-in period to facilitate adoption and implementation of the measure at the end of 1992. These interim standards and transitional arrangements are set forth in section IV.
The risk-based guidelines apply on a consolidated basis to any bank holding company with consolidated assets of $500 million or more. The risk-based guidelines also apply on a consolidated basis to any bank holding company with consolidated assets of less than $500 million if the holding company (i) is engaged in significant nonbanking activities either directly or through a nonbank subsidiary; (ii) conducts significant off-balance-sheet activities (including securitization and asset management or administration) either directly or through a nonbank subsidiary; or (iii) has a material amount of debt or equity securities outstanding (other than trust preferred securities) that are registered with the Securities and Exchange Commission (SEC). The Federal Reserve may apply the risk-based guidelines at its discretion to any bank holding company, regardless of asset size, if such action is warranted for supervisory purposes.4
The risk-based guidelines are to be used in the inspection and supervisory process as well as in the analysis of applications acted upon by the Federal Reserve. Thus, in considering an application filed by a bank holding company, the Federal Reserve will take into account the organization’s risk-based capital ratio, the reasonableness of its capital plans, and the degree of progress it has demonstrated toward meeting the interim and final risk-based capital standards.
The risk-based capital ratio focuses principally on broad categories of credit risk, although the framework for assigning assets and off-balance-sheet items to risk categories does incorporate elements of transfer risk, as well as limited instances of interest-rate and market risk. The risk-based ratio does not, however, incorporate other factors that can affect an organization’s financial condition. These factors include overall interest-rate exposure; liquidity, funding, and market risks; the quality and level of earnings; investment or loan-portfolio concentrations; the quality of loans and investments; the effectiveness of loan and investment policies; and management’s ability to monitor and control financial and operating risks.
In addition to evaluating capital ratios, an overall assessment of capital adequacy must take account of these other factors, including, in particular, the level and severity of problem and classified assets. For this reason, the final supervisory judgment on an organization’s capital adequacy may differ significantly from conclusions that might be drawn solely from the level of the organization’s risk-based capital ratio.
The risk-based capital guidelines establish minimum ratios of capital to weighted-risk assets. In light of the considerations just discussed, banking organizations generally are expected to operate well above the minimum risk-based ratios. In particular, banking organizations contemplating significant expansion proposals are expected to maintain strong capital levels substantially above the minimum ratios and should not allow significant diminution of financial strength below these strong levels to fund their expansion plans. Institutions with high or inordinate levels of risk are also expected to operate above minimum capital standards. In all cases, institutions should hold capital commensurate with the level and nature of the risks to which they are exposed. Banking organizations that do not meet the minimum risk-based standard, or that are otherwise considered to be inadequately capitalized, are expected to develop and implement plans acceptable to the Federal Reserve for achieving adequate levels of capital within a reasonable period of time.
The Federal Reserve may determine that the regulatory capital treatment for a banking organization’s exposure or other relationship to an entity not consolidated on the banking organization’s balance sheet is not commensurate with the actual risk relationship of the banking organization to the entity. In making this determination, the Federal Reserve may require the banking organization to treat the entity as if it were consolidated onto the balance sheet of the banking organization for risk-based capital purposes and calculate the appropriate risk-based capital ratios accordingly, all as specified by the Federal Reserve.
The Board will monitor the implementation and effect of these guidelines in relation to domestic and international developments in the banking industry. When necessary and appropriate, the Board will consider the need to modify the guidelines in light of any significant changes in the economy, financial markets, banking practices, or other relevant factors.

*
Regulation Q—Capital Adequacy of Bank Holding Companies, Savings and Loan Holding Companies, and State Member Banks, revised the Board’s risk-based and leverage capital requirements for banking organizations into a harmonized integrated regulatory framework. See Regulation Q (12 CFR 217) at 3-2100.
1
Supervisory ratios that relate capital to total assets for bank holding companies are outlined in appendixes B and D of this part.
2
The risk-based capital measure is based upon a framework developed jointly by supervisory authorities from the countries represented on the Basle Committee on Banking Regulations and Supervisory Practices (Basle Supervisors’ Committee) and endorsed by the Group of Ten Central Bank Governors. The framework is described in a paper prepared by the BSC entitled “International Convergence of Capital Measurement,” July 1988.
3
Banking organizations will initially be expected to utilize period-end amounts in calculating their risk-based capital ratios. When necessary and appropriate, ratios based on average balances may also be calculated on a case-by-case basis. Moreover, to the extent banking organizations have data on average balances that can be used to calculate risk-based ratios, the Federal Reserve will take such data into account.
4
[Reserved]
Back to top